Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 129
NG -- CHECK CONNECTION OF CONNECTORS
OK -- USE SIMULATION METHOD TO CHECK
2. CHECK CONNECTION OF CONNECTORS
(a) Turn the ignition switch off.
(b) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
(c) Check that the connectors are properly connected to the center airbag sensor assembly and the front airbag sensor RH.
OK:
The connectors are properly connected.
NG -- CONNECT CONNECTORS, THEN GO TO STEP 1
OK -- Continue to next step.
3. CHECK FRONT AIRBAG SENSOR RH CIRCUIT (OPEN)
(a) Disconnect the connectors from the center airbag sensor assembly and the front airbag sensor RH.
(b) Using a service wire, connect D23-29 (+SR) and D23-27 (-SR) of connector "B".
NOTICE:
Do not forcibly insert a service wire into the terminals of the connector when connecting.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- CHECK INSTRUMENT PANEL WIRE (OPEN)
OK -- Continue to next step.
4. CHECK FRONT AIRBAG SENSOR RH CIRCUIT (SHORT)
(a) Disconnect the service wire from connector "B".
