0924
Control module has an internal error. (P0606)
Possible cause:
- Test control unit.
Affected functions:
- Engine diagnosis
-------------------------------------------------
Test 1: Test control unit.
1. Test control unit.
Test control unit.
Possible cause and remedy
- Erase fault memory and start engine.
- Reread fault memory of control unit N3/10 (ME-SFI [ME] control unit).If fault reoccurs, replace component N3/10 (ME-SFI [ME] control
unit).
Read coding and transfer to the new control unit.End of test
0940
S9/1 (Stop lamp switch)
Possible cause:
- S9/1 (Stop lamp switch)
Affected functions:
- Stop lamp
-------------------------------------------------
Test 1: Check component S9/1 (Stop lamp switch).
1. Check component S9/1 (Stop lamp switch).
Test sequence
- Switch on ignition.
Status of relevant actual value:
- Stop lamp switch:Warning!
Specified value
- Switch S9/1 (Stop lamp switch) operated:OPERATED
- Switch S9/1 (Stop lamp switch) not operated:NOT OPERATED
The actual value is supplied through CAN bus from component N47-5 (ESP, SPS [PML] and BAS control unit).Question
- Is the actual value o.k.?
YES
The actual value is okay.End of test
NO
The actual value is not o.k.Possible cause and remedy
- Read fault memory from control unit ESP and rectify faults.
