1.1.3. Perform mechanical inspection of component M16/6 (Throttle valve actuator).
Test sequence
- Switch off ignition.
- Expose component M16/6 (Throttle valve actuator).
- Slowly operate throttle flap by hand up to full load.
Specified value
- The throttle valve must not stick and must close by internal spring force.
Question
- Is the test o.k?
YES
The test is o.k..End of test
NO
The test is not o.k..Possible cause and remedy
- Check intake tract for residue and clean if necessary.If no residue is present, replace component M16/6 (Throttle valve actuator).
1316
Throttle valve jamming (iced up) (P2072)
Possible cause:
- M16/6 (Throttle valve actuator)
Affected functions:
- Engine output
-------------------------------------------------
Test 1: Check component M16/6 (Throttle valve actuator).
1. Check component M16/6 (Throttle valve actuator).
Test 1.1: Throttle valve jamming (iced up)
1.1. Throttle valve jamming (iced up)
Fault freeze frame data
Intake air temperature [锟斤拷C] ( Limit value : 1 锟斤拷C )
Test 1.1.1: Check component M16/6 (Throttle valve actuator) using actual value.
Test 1.1.2: Check internal resistance of component M16/6 (Throttle valve actuator).
Test 1.1.3: Perform mechanical inspection of component M16/6 (Throttle valve actuator).
1.1.1. Check component M16/6 (Throttle valve actuator) using actual value.
Warning!Communication with ECU required.
1.1.2. Check internal resistance of component M16/6 (Throttle valve actuator).
Figure legend
- A -ConnectionTest cable 35-pin socket box
- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)
- 05 -35-pin socket box
- 050 -126-pin socket box
- 108 -Test cable 266 589 01 63 00
- N3/10 (ME-SFI [ME] control unit)
- II 1-63ConnectionTest cable
