Testing of maximum power consumption may be conducted for no longer than 5 s.Specified value
- Amperage[1.0...1.8] A
Question
- Is the measurement value OK?
YES
The measurement value is OK.End of test
NO
The measurement value is not OK.Possible cause and remedy
- N10/1f43 (Fuse 43)
- Line from component Y49/7 (Right camshaft exhaust solenoid) to component N3/10 (ME-SFI [ME] control unit)
- Y49/7 (Right camshaft exhaust solenoid)
End of test
0067
Component Y49/7 (Right camshaft exhaust solenoid) has an open circuit in the wiring. (P0013)
Possible cause:
- Y49/7 (Right camshaft exhaust solenoid)
- Voltage supply via component Z7/38 (Circuit 87 M1i connector sleeve)
Affected functions:
- Engine diagnosis
- Engine output
-------------------------------------------------
Test 1: Power supply
Test 2: Check component Y49/7 (Right camshaft exhaust solenoid).
1. Power supply
Voltage supply via component Z7/38 (Circuit 87 M1i connector sleeve)
Possible cause and remedy
- Check voltage supply according to wiring diagram.
2. Check component Y49/7 (Right camshaft exhaust solenoid).
Test 2.1: Test actuation of component Y49/7 (Right camshaft exhaust solenoid).
Test 2.2: Test current consumption of component Y49/7 (Right camshaft exhaust solenoid).
2.1. Test actuation of component Y49/7 (Right camshaft exhaust solenoid).
Test prerequisite
- Engine at idle
- Vehicle stationary
- Coolant temperature > 80锟斤拷 C
- Time since engine start> 60 s
Status of relevant actual value:
- Temperature of coolant:Warning! Communication with ECU required.
Note
- After the actuation it may be necessary to erase the fault memory!
Proceed to 'Actuation' with F2
2.2. Test current consumption of component Y49/7 (Right camshaft exhaust solenoid).
