End of test
NO
The measurement values are not OK.Possible cause and remedy
- Check lines between components N73 (EIS [EZS] control unit) and N10/1 (Driver-side SAM control unit with fuse and relay module) and
repair or replace if necessary.
- Fuse and component F34 (Interior fuse box)
Continue with button F2
Possible cause and remedy
- Check component N10/1 (Driver-side SAM control unit with fuse and relay module).
Question
- Continue troubleshooting in control unit N10/1 (Driver-side SAM control unit with fuse and relay module)?
2.1.3.2.1.11. No further information available.
2.1.3.2.1.12. Check power supply at control unit Y3/8n4 (Fully integrated transmission control (VGS) control unit).
Operation number of operation texts and work units or standard texts and flat rates:27-0641Test prerequisite
- Battery voltage is OK.
- Fuse N10/1f46 (Fuse 46) in component N10/1 (Driver-side SAM control unit with fuse and relay module) is o.k.
Test sequence
- Switch off ignition.
- Separate plug connection at transmission.
- Measure voltage in transmission wiring harness using a multimeter.
- Switch on ignition.
Measure direct voltage with multimeter between 5 and 4Specified value
- Voltage [8,5...16,4] V
Question
- Is the measurement value OK?
YES
The measurement value is OK.Further causes
- The diagnosis line is not OK
