2.2. Check component M16/6m1 (Actuator motor) by means of actuation.
Test prerequisite
- Operate engine at idling speed.
Note
- If the throttle valve angle is< 1,1锟斤拷, unmetered air may be present.
Status of relevant actual value:
- Throttle valve angle:Warning! Communication with ECU required.
Move on to actuation with button F2
2.3. Check internal resistance of component M16/6m1 (Actuator motor).
Figure legend
- A -ConnectionTest cable 35-pin socket box
- 001 -Sockets of component N3/10 (ME-SFI [ME] control unit)
- 05 -35-pin socket box
- 050 -126-pin socket box
- 108 -Test cable 266 589 01 63 00
- N3/10 (ME-SFI [ME] control unit)
- II 1-63ConnectionTest cable
- III 64-126ConnectionTest cable
Warning!
- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).
Continue to test with button F2
Test sequence
- Switch off ignition.
- Disconnect coupling M at component N3/10 (ME-SFI [ME] control unit).
- Measure resistance with multimeter between sockets (M.75) 75 and (M.74) 74 of the 126-pole socket box tester.
Specified value
- Resistor[1...10]ohms
Question
- Is the measurement value OK?
