NO
There is no open circuit in the CAN bus lines.Cause
- There is an internal fault in component N89 (Transmission oil additional pump control unit).
- There is an internal fault in component M42 (Electric transmission oil pump).
REMEDY
- Replace component M42 (Electric transmission oil pump).
NOTE
- No further actions are required.
End of test
NO
The measurement value is not OK.Possible cause and remedy
- Check fuse F1/6f76 (Fuse 76) in component N10/1 (Front SAM control unit with fuse and relay module) for tight installation and corrosion.
- Check lines and plug connection on components M42 (Electric transmission oil pump) and N10/1 (Front SAM control unit with fuse and relay
module) for loose contacts, damages, interruptions, etc. and if necessary, repair or replace parts.