Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 110
WIRING DIAGRAM
Refer to DTCs C0226/21, C0236/22, C0246/23, C0256/24 and C1225/25 See: C Code Charts/C0226/Vehicle Stability Control System (to
12/2010).
INSPECTION PROCEDURE
NOTICE:
When replacing the ABS & TRACTION actuator assembly, perform zero point calibration See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Acceleration/Deceleration Sensor/Testing and Inspection/Calibration (to
12/2010).
HINT
When C1241/41 is output along with C0278/11, inspect and repair the trouble areas indicated by C1241/41 first.
PROCEDURE
1. INSPECT FUSE (ABS/VSC NO.2 FUSE)
(a) Remove the ABS/VSC No. 2 fuse from the engine room relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- CHECK FOR SHORT IN ALL HARNESS AND CONNECTOR CONNECTED TO FUSE AND REPLACE FUSE
OK -- Continue to next step.
2. INSPECT SKID CONTROL ECU (+BS TERMINAL AND GND CIRCUIT)
(a) Disconnect the skid control ECU connector.
