Toyota Avalon V6-3.5L (2GR-FE) Manufacturer Code Page 1132
(a) Check that the yaw rate and acceleration sensor has been installed properly See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Yaw Rate Sensor/Service and Repair/Installation (to 12/2010).
OK:
The sensor is tightened to the specified torque.
The sensor is not tilted.
NG -- INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY
OK -- Continue to next step.
3. INSPECT YAW RATE AND ACCELERATION SENSOR (IG TERMINAL)
(a) Disconnect the yaw rate and acceleration sensor connector.
(b) Turn the ignition switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (IG CIRCUIT)
OK -- Continue to next step.
4. INSPECT YAW RATE AND ACCELERATION SENSOR (GND TERMINAL)
(a) Disconnect the yaw rate and acceleration sensor connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NOTICE:
Check the yaw rate and acceleration sensor signal after replacement See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure (to 12/2010).
HINT
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next
step See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Symptom Related
Diagnostic Procedures/Vehicle Stability Control System/Problem Symptoms Table (to 12/2010).
