1.2. Check component M16/6m1 (Actuator motor) by means of actuation.
Test prerequisite
- Operate engine at idling speed.
Note
- If the throttle valve angle is< 1,1锟斤拷, unmetered air may be present.
Status of relevant actual value:
- Throttle valve angle:Warning! Communication with ECU required.
Move on to actuation with button F2
1.3. Perform mechanical inspection of component M16/6 (Throttle valve actuator).
Test sequence
- Switch off ignition.
- Expose component M16/6 (Throttle valve actuator).
- Slowly operate throttle flap by hand up to full load.
Specified value
- The throttle valve must not stick and must close by internal spring force.
Question
- Is the test o.k?
YES
The test is o.k..End of test
NO
The test is not o.k..Possible cause and remedy
- Check intake tract for residue and clean if necessary.If no residue is present, replace component M16/6 (Throttle valve actuator).
0224
M16/6 (Throttle valve actuator) : Perform throttle valve adaptation. (P2176)
Possible cause:
- M16/6 (Throttle valve actuator)
Affected functions:
- Engine diagnosis
- Engine running
-------------------------------------------------
Test 1: Learning of the throttle valve stop
1. Learning of the throttle valve stop
Warning!Communication with ECU required.
0228
M16/6 (Throttle valve actuator) : Throttle valve jamming (iced up) (P0638)
Possible cause:
- M16/6 (Throttle valve actuator)
