- Connection A of test cable 108 may NOT be connected to connection B of the 126-pin socket box (050).
Continue to test with button F2
Test sequence
- Switch off ignition.
- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).
- Measure direct current with multimeter between sockets [F.4] 100 and [F.17] 113 of the 126-pole socket box tester.
- Switch on ignition.
Specified value
- Amperage[0,1...0,3] A
- Component M3 (Fuel pump assembly) is switched on and is heard to run.
Question
- Is the measurement value OK?
YES
The test was okay.End of test
NO
The measurement value is not OK.Possible cause and remedy
- Lines to component N10/2kA (Fuel pump relay)
- N10/2kA (Fuel pump relay)
End of test
0490
Relay 'Fuel pump'
Possible cause:
- N10/2kA (Fuel pump relay)
Affected functions:
- Engine start
-------------------------------------------------
