Test sequence
- Switch off ignition.
- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).
- Measure resistance with multimeter between sockets [M.51] 51 and [F.3] 99 of the 126-pole socket box tester.
Specified value
- Resistor[11...17]ohms
Question
- Is the measurement value OK?
YES
The measurement value is OK.Note
- In the event of stored faults with a high fault frequency count or in the event of customer complaints, check lines and connectors for loose
contact and corrosion..
NO
The measurement value is not OK.Test sequence
- Switch off ignition.
- Connect shop-made test cable set to component Y62y2 (Fuel injector cylinder 2).
- Measure resistance with multimeter between pins (Y62) 1 and (Y62) 2
Specified value
- Resistor[11...13]ohms
Question
- Is the measurement value OK?
YES
The measurement value is OK.Possible cause and remedy
- Lines to component Y62y2 (Fuel injector cylinder 2)
NO
The measurement value is not OK.Possible cause and remedy
