Test sequence
- Switch off ignition.
- Remove fuel rail together with component Y62 (Fuel injectors).
- Connect socket box (35-pin) to component N3/10 (ME-SFI [ME] control unit).
- Connect socket box (126-pin) to component N3/10 (ME-SFI [ME] control unit).
- Insert bridge.:
- Bridge between socket (F.2) 98 of the 35-pole socket box tester and socket (F.17) 113 of the 126-pole socket box tester.
- Switch on ignition.
- Component M3 (Fuel pump) runs.
- Hold component Y62 (Fuel injectors) in a vessel and briefly operate manually with shop-made test cable set at sockets 5 and 9 of the 35-pin
socket box.
Specified value
- Fuel injectors should eject fuel uniformly.
Question
- Was the test o.k.?
YES
The test was okay.End of test
NO
The test was not okay.Possible cause and remedy
- Y62 (Fuel injectors)
End of test
2.1.4. Check exhaust system for leaks.
Possible cause of fault
- Leaks
Possible remedy
- Check entire exhaust system for leaks.
2.1.5. Check component Y58/1 (Purge control valve).
Test 2.1.5.1: Actuate component Y58/1 (Purge control valve).
Test 2.1.5.2: Test current consumption of component Y58/1 (Purge control valve).
