- The alternator regulator is defective
End of test
NO
The measurement value is not OK.Possible cause and remedy
- Check lines and connectors for proper connection and locking, loose contact, damage, contamination and corrosion.
- Check engine wiring harness for correct routing, chafe marks and proper contact at the control unit.
For cleaning, the connector may only be blown out with compressed air! Cleaning agents must not be used.
NO
The measurement value is not OK.Possible cause and remedy
- Check LIN lines between control unit N3/10 (ME-SFI [ME] control unit) and component Generator.
Continue with button F2
Test sequence
- Switch off ignition.
- Reconnect detached couplings.
- Disconnect 2-pin plug from component Generator.
- Connect adapter cable no. 220 589 00 99 35 at component Generator.
- Connect multimeter to red socket of adapter and socket box.
- Measure direct voltage with multimeter between pin [G2] 2 and socket [ M.45 ] 45 of the 126-pole socket box tester.
- Switch on ignition.
Specified value
- Voltage [approx.0 mV ]
Question
- Is the measurement value OK?
YES
The measurement value is OK.Other possible cause of fault
- The alternator regulator is defective
End of test
NO
The measurement value is not OK.Possible cause and remedy
- Check lines and connectors for proper connection and locking, loose contact, damage, contamination and corrosion.
- Check engine wiring harness for correct routing, chafe marks and proper contact at the control unit.
For cleaning, the connector may only be blown out with compressed air! Cleaning agents must not be used.
NO
Remedy
- Repair component Poly-V-belt.
End of test
0405
Component Y16/2 (Heating system shutoff valve) has a short circuit to positive. (P0115)
Possible cause:
- Y16/2 (Heating system shutoff valve)
Affected functions:
- Heating
-------------------------------------------------
Test 1: Check component Y16/2 (Heating system shutoff valve).
1. Check component Y16/2 (Heating system shutoff valve).
