The measurement value is OK.Possible cause and remedy
- Replace component Floor-mounted shift.
End of test
NO
The measurement value is not OK.Possible cause and remedy
- Check fuse f55 (voltage supply from control unit ESM) in component N10/1 (Front SAM control unit with fuse and relay module).
- Check all affected plugs, connectors and electrical components for damage, loose contact, corrosion etc. and repair if necessary.
End of test
Part 2
CAN controller: CAN bus OFF
1.3.2.1.5. Check power supply at control unit EZS.
Test prerequisite
- Battery voltage is OK.
- Fuse F34.f36 is OK.
Status of relevant actual value:
- Power supply:Warning! Communication with ECU required.
Specified value
- Power supply [11.0...14.5] V
Question
- Is the actual value o.k.?
YES
The actual value is okay.Possible cause and remedy
- In the event of stored faults with a high fault frequency count or in the event of customer complaints, check lines and connectors for loose
contact and corrosion..
- Check alternator.
End of test
NO
The actual value is not o.k.Test sequence
- Switch off ignition.
- Detach sockets A and C at component N73 (EIS [EZS] control unit).
- Measure direct voltage with multimeter between sockets (N73) B.2 and (N73) C.1
Specified value
- Voltage [11.0...14.5] V
Question
- Are the measurement values OK?
YES
The measurement values are OK.Possible cause and remedy
- Inspect connector B,C at control unit N73 (EIS [EZS] control unit) for damage, correct connection, loose contact and corrosion and repair, if
necessary.
- N73 (EIS [EZS] control unit)
End of test
NO
The measurement values are not OK.Possible cause and remedy
- Check lines between components N73 (EIS [EZS] control unit) and N10/1 (Driver-side SAM control unit with fuse and relay module) and
repair or replace if necessary.
- Fuse and component F34 (Interior fuse box)
Continue with button F2
