Sunday, October 14, 2018

^ At the online DVD order site, by clicking on the FAQs link (see ORDERING A DVD).***Acura Truck MDX V6-3.7L Technical Service Bulletin # 11-014 Date:


^ At the online DVD order site, by clicking on the FAQs link (see ORDERING A DVD).***Acura Truck MDX V6-3.7L Technical Service Bulletin # 11-014 Date:



110617



Electrical - VSA Indicator ON/Multiple DTC's Set



11-014



June 17, 2011



Applies To:



2007-11 MDX - ALL



VSA Indicator or Trailer Stability Assist Warning Is On Intermittently with DTC 59-1, 66-1, 67-1, or 69-1, or Won't Come Out of Park



SYMPTOM



The VSA indicator or the trailer stability assist warning is on with DTCs 59-1, 66-1, 67-1, or 69-1, or you can't move the shift lever out of Park. The



symptoms may be intermittent, and you may not be able to duplicate them after clearing the DTCs.



PROBABLE CAUSE



The brake pedal position switch is malfunctioning.



CORRECTIVE ACTION



Replace the brake pedal position switch.



PARTS INFORMATION



Brake Pedal Position Switch:



P/N 36750-TR2-A01



WARRANTY CLAIM INFORMATION



78



The normal warranty applies.



Operation Number: 7381A2



Flat Rate Time: 0.2 hour



Failed Part: P/N 36750-SJA-013



Defect Code: 03217



Symptom Code: 03205



Skill Level: Repair Technician



REPAIR PROCEDURE



1. Remove the driver's side dashboard undercover:



^ Unlock the dashboard undercover lock knob by turning it 90 degrees.



^ Gently pull down the rear edge of the undercover to detach the clip.



^ Disconnect the footwell light connector and the ambient light connector, then detach the harness clip.



^ Pull the undercover away to release the pins from the holders.



79



2. Unplug the 4P brake pedal position switch connector.



3. Turn the brake pedal position switch counterclockwise 45 degrees and remove it.



4. Remove the old brake pedal position switch insert (green) from the bracket.



5. Install the new brake pedal position switch insert (white) onto the bracket.



NOTE:



The green and white brake pedal position switch inserts are not interchangeable.



80



6. To set the gap of the brake pedal position switch, do this:



^ Lift up on the brake pedal by hand.



^ Push in the brake pedal position switch until its plunger is fully pressed (threaded end touching the pad on the brake pedal arm).



^ Turn the switch clockwise 45 degrees to lock it. The gap between the brake pedal position switch and the pad is automatically adjusted



correctly.



7. Connect the 4P brake position switch connector.



8. Make sure the brake lights go off when the pedal is released.



9. Install the driver's dashboard undercover:



^ Reconnect the harness clip, the ambient light connector, and the footwell light connector.



^ Push up the dashboard undercover to connect the pins to the holders.



^ Gently push up the rear edge of the undercover to reattach the clips.



81



^ Re-lock the lock knob by turning it 90 degrees.