Test 1.1.3.1.2: Wiring diagram of CAN bus
1.1.3.1.1. Arrangement diagramNOTESome of the control units listed are special equipment and not installed in every vehicle.
Location diagram (with special equipment)
Figure legend
- A1 (Instrument cluster)
- A89 (DTR controller unit)
- N3/9 (CDI control unit)
- N3/10 (ME-SFI [ME] control unit)
- N15/3 (ETC [EGS] control unit)
- N15/5 (Electronic selector lever module control unit)
- N47-5 (ESP, SPS [PML] and BAS control unit)
- N51 (AIRmatic with ADS control module)
- N63/1 (DTR control module)
- N71 (Headlamp range adjustment control module)
- N73 (EIS [EZS] control unit)
- N80 (Steering column module)
- N93 (Central gateway control unit)
- N97 (Rear axle level control system control module)
- X11/4 (Diagnosis test connector)
- X30/5 (Left voltage distributor (CAN) connector)
- Installation point of plug connection X30/5 (Left voltage distributor (CAN) connector)
- Communication with ECU required
1.1.3.1.2. Wiring diagram of CAN bus
Note
- WIS is not available on this system.
- It is not possible to display the requested WIS document [ pe0019p2200da ].
- You can start WIS on another system and display the WIS document by entering the document number [ pe0019p2200da ] in the 'Contents'
