P179C46
Control unit 'DIRECT SELECT' has a malfunction. There is an error in the calibration or parameterization memory.
Possible cause:
A80 (Intelligent servo module for DIRECT SELECT)
Affected functions:
Drive position selection
Test 1: Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)'
1. Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)'
Operation number of operation texts and work units or standard texts and flat rates:270641Possible cause and remedy
Internal fault in control unit
Replace component A80 (Intelligent servo module for DIRECT SELECT).
Additional measures
Perform initial startup.
Continue with button "F2"
Initial startup
The following procedure will guide you through all steps required to perform a complete initial startup of system ISM.Preconditions
The new control unit must have already been installed.
You will be guided through the following steps
Detach transport protection.
Program control unit.
Personalizing2010 Mercedes Benz E 63 AMG Sedan (212.077) V86.3L (156.985)
Copyright ? 2013, ALLDATA
10.52SS
Page 973
Activating
Perform calibration.
Start process with button F2.
Warning!Warning: Connect battery charger. Make sure that the diagnostic plug is properly seated in the diagnostic socket. The
diagnostic connector must remain plugged in to the vehicle. Switch off all electrical consumers. If possible, do not perform any
procedures on the vehicle during control unit programming.
Warning!Communication with ECU required.
Control unit 'DIRECT SELECT' has a malfunction. There is an error in the calibration or parameterization memory.
Possible cause:
A80 (Intelligent servo module for DIRECT SELECT)
Affected functions:
Drive position selection
Test 1: Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)'
1. Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)'
Operation number of operation texts and work units or standard texts and flat rates:270641Possible cause and remedy
Internal fault in control unit
Replace component A80 (Intelligent servo module for DIRECT SELECT).
Additional measures
Perform initial startup.
Continue with button "F2"
Initial startup
The following procedure will guide you through all steps required to perform a complete initial startup of system ISM.Preconditions
The new control unit must have already been installed.
You will be guided through the following steps
Detach transport protection.
Program control unit.
Personalizing2010 Mercedes Benz E 63 AMG Sedan (212.077) V86.3L (156.985)
Copyright ? 2013, ALLDATA
10.52SS
Page 973
Activating
Perform calibration.
Start process with button F2.
Warning!Warning: Connect battery charger. Make sure that the diagnostic plug is properly seated in the diagnostic socket. The
diagnostic connector must remain plugged in to the vehicle. Switch off all electrical consumers. If possible, do not perform any
procedures on the vehicle during control unit programming.
Warning!Communication with ECU required.
