Monday, February 15, 2016

Mercedes Benz E 550 4MATIC Sedan (212.090) V8-5.5L (273.970) Campaign - Front Floor Jack Pad Replacement

2010 Mercedes Benz E 550 4MATIC Sedan (212.090) V8-5.5L (273.970)     Campaign - Front Floor Jack Pad Replacement

Vehicle: All Technical Service Bulletins

Campaign - Front Floor Jack Pad Replacement

FILE:

SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER

PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER

Campaign No. 2010080001, August 2010

TO: ALL MERCEDES-BENZ CENTERS

SUBJECT: Model 212, Model Year 2010

Replace Front Floor Jack Pad

This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that an

incorrect front floor jack pad may have been installed. Dealers will replace the front floor jack pad at the next workshop visit.

Prior to performing this Service Campaign:

^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.

^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.

Please note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.

Approximately 833 vehicles are affected.

Procedure

1. Lift vehicle.

2. Remove mounting plug (arrow, Figure 1) from front floor jack pad (A).

3. Remove floor jack pad (A, Figure 1) from front axle carrier.

4. Apply wax to front axle carrier in area of floor jack pad, from inside (through hole in axle carrier).

5. Install new floor jack pad (A, Figure 1).

Equipment

Contact our equipment provider SPX SSEP to order the SATA preservation wax gun applicator.

Primary Parts Information

Note:

^ Please be aware that only the part number(s) referenced in the Campaign Bulletin is/are approved for use to repair the vehicle. Repairs performed using any other part(s) will not have been performed in accordance with the campaign. Accordingly, warranty claims submitted with reference to an improper part number(s) will be denied.

^ The following allowable labor operation should be used when submitting a warranty claim for this repair:

Warranty Information

-----------------------------------------------------Page 1-----------------------------------------------------